- Insert Dimensions
- Height
- Columns and Rows
- Material
1/8" clear acrylic
Drawer Dimensions for Cubby Grid
We need to know the size of your drawer. Be as accurate as you can. We'll take off a little each way (one eighth inch, to be exact) to ensure that the cubby grid fits into your drawer.
Enter your Drawer's Tight Internal Dimensions
(in inches)
Use decimals, not fractions.(Helpful chart)
Not confident about your measurements? See our tips below.
I want a maple Cubby Grid
Follow these expandable notes on each page of this wizard.
For maple Cubby Grids, we have a 7" minimum in both width and depth.
What's the best way to measure my drawer?
Having trouble trusting your tape measure?
Check out our foolproof drawer measuring rulers at our Etsy store.
If you feel confident in your tape measure, the best way to get an accurate measurement is to measure your drawer using multiple methods. The easiest way to measure - but not necessarily the most accurate - is in the following manner. (Image below)
For each dimension, measure the drawer in three places - front, middle, and back - to check for consistency. Enter the smallest measurement for each dimension in the fields above.
Sometimes the tip of a tape measure will be bent or broken. Even a new tape measure may have this problem! If that's the case or if you are unsure, try this:
Instead of measuring by starting from zero (the tip), you can measure starting from 10" or any other round number. Then just subtract the start number from your measurement.
It is especially difficult to measure to the corners of the drawer. If using the +10 method above, it can be difficult to see exactly where the corners on the bottom of the drawer begin. Using the following credit card method can help.
Most credit cards are a standard size: 2.125" wide. Lay a credit card against a side of the drawer. Measure from one end to the credit card. Then add in the width of the card.
Having difficulty reaching or seeing the measure points?
Sometimes it is hard to get a clean reading on the back or front of the drawer due to nearby obstructions. If your drawer does not fully extend out of the cabinet, it can be challenging to get a good measurement.
If you have trouble, the best strategy is to completely remove your drawer from the cabinet. At first it may seem that there's no way to get it out, but keep looking things over and you will find the secret. It is extremely unlikely that your drawer slides (or "runners") will not allow the quick removal of the drawer. You should not have to unscrew anything!
Very large or very small drawers
The form above allows internal drawer widths and depths of between 4 and 31 inches.